BSA Test Stand:

This Automatic test stand is perfectly compatible with our HP and HPEIII units allowing for hardness measurements under ASTM D2240 Shore standards.

It is intended to reduce human error and produce consistent measurement results from operator to operator. The hardness tester may be clamped quickly and easily using the pick-up device on the test stand. There is also the option of a manual test stand.

Calibration device for HP and HPE II:

To comply with ISO 9000, the operator should regularly calibrate the equipment to ensure the accuracy of the Shore hardness tester. The calibration device allows for a quick check of the spring force, which can be adjusted in increments of ten for the different measuring ranges, including Shore A/B/0/C/D/DO and L, L/c.

DIN 53 505, EN ISO 868, NF EN ISO 868, ASTM D2240, JIS K 6253.

Shore Reference Test Blocks:

To maintain the accuracy of the measuring device according to the Shore standard, standard rubber blocks are utilized during frequent recalibrations. These blocks are securely held in a stainless steel holder.

The calibration sets are available with various plates, including single, 3, 5, or 6 plates, and can be accompanied by a DAkkS/DKD calibration certificate.

Shore Control Ring:

Control of the measuring distance with DAkkS/DKD / WKS Certificate

• 20 Shore
• 40 Shore
• 60 Shore
• 80 Shore

Hardtest – Software

Hardtest is one of the most prominent accessories applicable to both the DigiTest and the HPE line of equipment. It comes standard with a serial interface. The software designed to eliminate all human and other error factors.

Click here to request a personalized quote from our team!