Metal Testing Equipment
The NextGen testing frames provide a solution for high-capacity applications for a wide range of high-strength materials to meet all of your testing needs. Built according to industry standards, the NextGen SHM line features or latest TestPilot software which comes pre-programmed with some of the latest testing methods. TestPilot is designed for users to reach the most accurate results while providing an easy to use interface for even the most inexperienced users.
The SHM line is broken down into Class A, B, C, D and DP covering a wide variety of laboratory configurations. Each unit is built with different applications in mind for your benefit. Speak with a representative today to understand our complete line of servo hydraulic systems.
Repeatable results are constantly achieved through the NextGen SHM series combined with the TestPilot professional software. Suitable for high force applications, these units are offered with performance driven hydraulic packages with a complementary line of fixtures and accessories.
Products
NG-SHM CLASS DP - Servo Hydraulic Testing Machine
600kN-2000kN - Servo-Hydraulic Universal Testing Machine - Side Action Wedge Grip 2/4 columns, servo-controlled hydraulic
NG-SHM Class D - Servo Hydraulic Testing Machine
600kN-2000kN - Servo-Hydraulic Universal Testing Machine 2/4 columns, servo-controlled hydraulic
NG-SHM Class C - Servo Hydraulic Testing Machine
600kN-1000kN - Servo-Hydraulic Universal Testing Machine 6 column, servo-controlled hydraulic
NG-SHM Class B - Servo Hydraulic Testing Machine
300kN-3000kN - Servo-Hydraulic Universal Testing Machine 6 column, servo-controlled hydraulic
NG - EML Test Pilot Series - TestPilot Software
TestPilot is designed to enhance your ability to perform accurate and repeatable mechanical testing of materials, components and finished goods across a full spectrum of applications.
NG-SHM Class A - Servo Hydraulic Testing Machine
200kN-2000kN - Servo-Hydraulic Universal Testing Machine 4 or 6 column, servo-controlled hydraulic.
FAQs
Here are some fundamental differences between Class A and Class DP Servo Hydraulic Universal Tensile Testers:
- Class A can only perform tension or compression test, while Class DP can perform tension and compression cyclical test.
- Class DP is much heavier system than Class A. It is a robust machine equipped with a heavier bottom platen and top platen. It also has a much larger cylinder.
- Class DP tensile tester uses I type load cell. This is an more advanced, precise and reliable load cell relative to Class A system.
- During specimen clamping Class DP Servo Hydraulic machine has smaller initial force than Class A. That means that Class DP has smaller rate of damage on specimens during clamping.
- Class DP system is shock absorbent allowing for a minimum ground shock upon tensile specimen break.
- Class DP is easier for tensile testing in general. It is more user friendly, accessible and accurate. When it comes to Class A tensile tester, the operator needs to use a small ladder when loading the specimens, because the tensile test space is in the upper section of the tester.
Learn more by contacting us today or submit quote request.